Do not use Mapegrout Patch 218 to repair surfaces subject to high abrasion. Use Mapegrout Thixotropic.. 

Do not use Mapegrout Patch 218 on smooth concrete surfaces. Roughen the surface thoroughly.. 

Do not use Mapegrout Patch 218 for pouring or pumping into the formwork. Use Mapefill 318.. 

Do not add cement or admixtures to Mapegrout Patch 218.. 

Do not add water once the mix has begun to set.. 

Do not use Mapegrout Patch 218 at temperatures lower than +5°C.. 

Do not use Mapegrout Patch 218 if the bag has been damaged or opened. . 

Preparing the mix

• To mix one 25 kg bag of Mapegrout Patch 218, pour 3.5 to 4.0 kg of water into a clean container (depending on consistency required).

• Gradually add the Mapegrout Patch 218 to the water while mixing continuously at low speed. Continue for 1 to 2 minutes, making sure the mix is well blended. Scrape free any unblended powder sticking to the bottom and sides of the container. Mix again for another 2 to 3 minutes until homogeneous.

Applying the mix

• For patching applications, the mix can be applied with a flat or gauging trowel with no need for formwork even on vertical and overhead surfaces. The recommended maximum thickness is 30 mm per layer. When a further layer of Mapegrout Patch 218 is necessary, it must be applied before the previous one has completely set.

General purpose, shrinkage-controlled, fibre-reinforced, patch repair mortar

* Purpose-made for patch repairs

* Easy to apply for wall & overhead repairs; no formwork needed

* Dries without shrinkage & cracking

* Repaired area remains level even after drying

* Fast drying

* High strength